Camera Mounting Instructions Threaded Mount

Step 1: Place the mount  at the desired  location,  assuring that it is at least 20cm from the ceiling.  Use a pencil to mark the holes.

DCS-2802KT_Camera_Threaded_Mounting

Step 2: Using a 6 mm drill bit, drill two 25 mm deep holes over  the  pencil  marks.  For  a plaster,  dr y wall,  or concrete wall, insert the plastic anchors to support the screws first.

DCS-2802KT_Camera_Threaded_Mounting

Step 3: Place the mount over the holes that are in the wall. Make sure to align the mount holes with the holes in the wall. Use the supplied  screws to attach the mount to the surface of the wall.

DCS-2802KT_Camera_Threaded_Mounting

Step 4: Rotate  the wing  nut counterclockwise  with  your fingers to slightly loosen it. Then move the bracket to the approximate desired position.

DCS-2802KT_Camera_Threaded_Mounting

Step 5: S crew  the  camera  onto  the  mounting  screw  by tightening the plastic finger nut.

DCS-2802KT_Camera_Threaded_Mounting

Step 6: Adjust the angle of the arm on the mounting bracket as required.Tighten the wing nut to lock the camera's position into place.

DCS-2802KT_Camera_Threaded_Mounting

Rank: 3