How do I setup my ADSL Ethernet modem for Internet access?

Step 1. Open up a web browser and type in theIP address of the DSL-300T (default is PressEnter.

Step 2. Enter the Login nameand password (default is admin/admin). Click onLogin.

Step 3. Click on the Setup tabat the top. Click on Connection on the left.

Step 4. Configure the following for yourconnection:

  • Type - Set the connection Type to PPPoA (asused in the UK)
  • Name - Type in the name for theconnection
  • Encapsulation - set the encapsulation asrecommended by your ISP
  • Username - Type in the ISP login username
  • Password - Type in the login password
  • Keep alive - leave default
  • MAX Fail - leave default
  • MTU - leave default
  • MRU - leave default
  • Set Route - enable set route(default)
  • VPI - set to ISP recommended settings (i.e. 0)(UK ADSL commonly uses VPI=0 and VCI=38)
  • VCI - set to ISP recommended settings (i.e.38) (UK ADSL commonly uses VPI=0 and VCI=38)
  • QoS - leave default
  • PCR - leave default
  • SCR - leave default

Click on Apply when done.

Step 5. Click on the Statustab at the top and then click on Connection Statuson the left side. The Connection information can be seen in the WANsection of the page.  Once connected, your machine will nowget the IP address from the ISP.

Step 6. Click on Tools at thetop. Click on System Commands on the left. Clickon Save All to permanently save the changes.

Rank: 1.5