How to Recover SOP ‑ DWL‑6700AP

Requirements:

Firmware 4.4.0.1_B006 or later 
Note: Recovery procedure only supports after v.4.4.0.1_B006
Download from site...

Step 1 – Press and hold reset button

Step 2 – Power on DWL-6700AP by connecting AP to the PoE on power injector

Step 3 – Wait for ALL LEDs to turn on (as below):


 
Once completed (as Step 3), release the reset button

Step 4 – Connect cable from LAN (on PoE Injector) to PC and configure the LAN card of the PC to:
IP: 192.168.0.x

Step 5
– Open a Web-browser and go to the recovery mode Web-UI (192.168.0.1)


 
Step 6 – Use the Web-UI to upload the firmware and wait approximately 60 seconds
Or open cmd.exe and enter:
ping 192.168.0.1 –t  
If it doesn’t respond then it has completed the recovery and go to Step 7

Step 7
– Once the above is completed, configure the LAN card of PC to:
10.90.90.x

Step 8 – Open a web browser and enter:
10.90.90.91

 

Username: admin
Password: admin (default)

You should now have the DWL-6700AP recovered and ready to configure.

 
 

 

 

Rank: 1.5

These may also help:

  • How to Setup AP Mode Basic Configuration - DWL-6700AP Read Answer
  • How to configure the Mac address filtering - DWL-6700AP Read Answer
  • How to Setup WDS with VLAN – DWL-6700AP Read Answer