How to Upgrade Firmware via HTTP DGS‑1510‑Series?

Note: Please always check the current firmware available on our site

http://www.dlink.com/uk/en/

Step 1 – To upgrade the firmware via http, please go to “Firmware Upgrade from HTTP”

Tools > Firmware Upgrade & Backup > Firmware Upgrade from HTTP
DGS_1510_how_to_upgrade_firmware_from_HTTP
 
Step 2 – Select unit options:

ALL – This will be used if the switch is configured in stack
1 - This will be used if the switch is single unit
Select the option that applies then, click “Browse” for the .had file.
Enter the “Destination File”. In our example we have used “1_20_B013
DGS_1510_how_to_upgrade_firmware_from_HTTP 

Click “Upgrade”

DGS_1510_how_to_upgrade_firmware_from_HTTP

 
You should receive the following message when upgrade has completed with success

D-Link
 
Step 3 – You will now need to make this file (.had) bootable when switch reboots. To do this you will need to go to “File System”

Management > File System > c
D-Link
 
Click the “c” to enter the sub menu of the system

Step 4 – Select the .had file that had been used to upgrade in Step 2. In our example it was named “1_20_B013”
D-Link
 
Click “Boot Up” – This should change to greyed out after

D-Link
 
Once clicked, you should receive the above “Success” message.

Step 5 – Save configuration

Save > Save Configuration

D-Link

D-Link
  
Click “Apply”

D-Link
 
Once saved, you should receive the above “Success” message

Step 6 – Reboot switch

Tools > Reboot System

D-Link 

Select “Yes”

D-Link
 
Click “Apply”

D-Link
 
Click “OK”

D-Link
 
Step 7 – To test the results, the below screen shot shows the switch on previous firmware versión

Before Reboot:

D-Link 

After reboot:

D-Link
 

Rank: 1.5