How to Configure Port Rate Limiting - DGS-1510-Series

Scenario:


Ixia1 DGS-1510 ------------ ------------- Ixia2
 
(Traffic generator 1)


Ixia1 continually sends packets to 1G full speed (about 760000Kbps) to Ixia2, but we hope which was receiving Ixia2 these packages with a speed limit 50000 Kbps.


To perform the indicated configuration follow these steps:

QoS > Port Rate Limiting

Port speed limit: set the output port10 (TX) speed limit 50000 Kbps, other parameters remain in default as follows.

DGS-1510 Series Configure Port Rate Limiting
 
2. Ixia1 keeps sending packets with full speed,but we can see the Ixia2 receive these packages with speed limit of 50000 Kbps.

DGS-1510 Series Configure Port Rate Limiting



 




Rank: 1.5

These may also help:

  • How to configure VLAN Filter / VLAN Access – DGS-1510-Series Read Answer
  • DGS-1510 Series How to Configure Stack Order and Priority Read Answer
  • How to Configure Port Rate Limiting - DGS-1510-Series Read Answer
  • How to Setup - Asymmetric VLAN with a Corporate and Guest Network – DGS-1510-Series Read Answer
  • How to Configure VLANs – Example (HTTP and CLI) DGS-1510-Series Read Answer
  • How to upgrade the firmware on your DGS-1510-28P with TFTP Server? Read Answer
  • How to Configure an IP address with CLI – DGS-1510- Series Read Answer
  • How to Configure Link Aggregation LACP - DGS-1510-28 Series? Read Answer
  • How to Configure SSH Connection DGS-1510-Series - CLI Read Answer
  • How to DHCP relay on DGS-1510 with multiple VLANs via CLI Read Answer
  • How to Setup VLANS - Scenario Configuration DGS-1510-Series Read Answer
  • How to Upgrade Firmware DGS-1510-Series - CLI Read Answer
  • How to Upgrade Firmware via HTTP DGS-1510-Series? Read Answer