How do I configure the audio settings (speaker and microphone) on my DCS‑942L?

Step 1: Open a web browser and enter the IP address of the camera in the address bar (default is 192.168.0.20). Press Enter.

Step 2: The default username is admin and the password field should be left blank. Click OK.

picture

Step 3: Click on Setup on the top menu bar.

picture

Step 4: Click Audio and Video from the menu on the left-hand side. To enable the speaker, check the Speaker option, and select a volume from the drop-down menu. To enable the microphone, check the Microphone option and select a volume from the drop-down menu.

picture

Click Save Settings to the left to save the current configuration.

Rank: 1.5

These may also help:

  • How do I change the LAN IP address of my camera? Read Answer
  • How do I configure motion detection on my camera? Read Answer
  • How do I configure recording to the Micro SD card on my DCS 942L Read Answer
  • How do I manually upgrade the firmware on my camera? Read Answer
  • How do I set an administrator (admin) password on my DCS-942L? Read Answer
  • How do you setup Motion Detection on my DCS 942L Read Answer
  • What do I do if I forget the login username & password of my camera? Read Answer