What if I forget the Admin password for my camera?

(How do I reset my camera to factory default settings?)

Note: After a factory reset you will need to re-register the camera with mydlink. Do not unplug the power during this procedure.

Step 1: With the unit on, place a paper clip into the hole on the back on the unit labeled Reset.

Step 2: Use the paperclip to press the button inside the hole for 10 seconds and release.

picture

Step 3: The unit will then reboot. Once the LED light on the front of the unit stops blinking, the unit is reset and all settings are restored to their defaults.

Rank: 1.5

These may also help:

  • How do I change the LAN IP address of my camera? Read Answer
  • How do I configure motion detection on my camera? Read Answer
  • How do I configure the audio settings (speaker and microphone) on my DCS-2136L? Read Answer
  • How do I find the IP address of my DCS-2136L and access the web-based user interface? Read Answer
  • How do I manually upgrade the firmware on my camera? Read Answer
  • How do I mount my camera to the wall or ceiling? Read Answer
  • How do I set an administrator (admin) password on my DCS-2136L? Read Answer
  • How do I set up and install my DCS-2136L? Read Answer