How do I set an administrator (admin) password on my DCS-2330L?
Note: mydlink Cloud Service registration requires the admin password.
Step 1: Open a web browser and enter the IP address of your camera in the address bar (default is 192.168.0.20). If you do not know the IP address of your camera, please refer to the section entitled “How do I find the IP address of my DCS-2330L and access the web-based user interface?” in this FAQ. Press Enter.
Step 2: The User Name for the administrator account is admin. Enter your administrator password in the Password field. If you have not changed this from the default, leave this field blank. Click OK.
Step 3: Click the Maintenance tab at the top of the page and then click Admin from the menu on the left hand side.
Step 4: To change the administrator password, enter a New Password under the Admin Password Setting section. Enter the password again in the Retype Password field to confirm.
Step 5: Click Save to save the settings.
Note: If you forget the administrator password, you will need to reset the device in order to gain access to the configuration interface.
These may also help:
- How do I access my mydlink camera remotely? Read Answer
- How do I change the LAN IP address of my camera? Read Answer
- How do I configure motion detection on my camera? Read Answer
- How do I configure the audio settings (microphone) on my DCS-2330L? Read Answer
- How do I find the IP address of my DCS-2330L and access the web-based user interface? Read Answer
- How do I manually upgrade the firmware on my camera? Read Answer
- How do I mount my camera to the wall or ceiling? Read Answer
- How do I set up and install my DCS-2330L? Read Answer
- What if I forget the Admin password for my camera? Read Answer
- Which types of motion detection are available on my IP camera? Read Answer