How do I set up scheduled recording in D‑ViewCam?

Step 1: Launch D-ViewCam and click the Schedule Configuration icon.

Step 2: Select the camera(s) you want to apply the recording schedule to, then create a schedule and click the Configure icon.


Step 3: Under Mode, ensure Always Record is selected.


Step 4: Under the Time section, specify the time when you want the recording to occur and click OK. You can also determine how many seconds you wish Pre-record and Post-record for when motion is detected.


Note: If you want to record audio, be sure to check the Record Audio box under the audio section.

Click OK to close the Encoding Options and click OK again to close Schedule Configuration.


Step 5: Click the Start Menu icon and click Start Recording Schedule.


Note: A red circle will appear in the top right corner of each camera with recording configured. This indicates that it is recording.


Rank: 1.5

Dit kan ook interessant zijn:

  • How do I access my mydlink camera remotely? Lees antwoord
  • How do I change the LAN IP address of my camera? Lees antwoord
  • What can I do when Active X fails to install during my mydlink camera setup? Lees antwoord
  • How do I configure motion detection on my camera? Lees antwoord
  • How do I configure the audio settings on my DCS-5020L? Lees antwoord
  • How do I enable a new camera in D-ViewCam? Lees antwoord
  • How do I manually upgrade the firmware on my camera? Lees antwoord
  • How do I mount my camera to a wall or ceiling? Lees antwoord
  • How do I reset my camera to factory default settings? Lees antwoord
  • How do I set an administrator (admin) password on my DCS-5020L? Lees antwoord
  • How do I set up and install my DCS-5020L? Lees antwoord
  • How do I set up motion detection and recording in D-ViewCam? Lees antwoord
  • How many types of motion detection are available on my IP camera? Lees antwoord