How do I set up motion detection and recording in D‑ViewCam?

Step 1: Launch D-ViewCam and click the Schedule Configuration icon.

Step 2: Select the camera(s) you want to apply the recording schedule to, create a schedule and click Configure.


Step 3: Under the Mode menu, select Record on Motion.


Step 4: Under the Original Video view, click and drag to draw a box or multiple boxes to determine the area(s) that you want to monitor for motion. You can also use the sliders to determine the Sensitivity and Frame Interval for motion detection.



Click OK to close the Encoding Options and click OK again to close Schedule Configuration.


Step 5: Click the Start Menu icon and click Start Recording Schedule.


A circle will appear in the top right corner of each camera configured for motion detection recording.


•Green = No Motion Detected

•Red= Motion Detected


Rank: 1.5

Dit kan ook interessant zijn:

  • How do I access my mydlink camera remotely? Lees antwoord
  • How do I change the LAN IP address of my camera? Lees antwoord
  • What can I do when Active X fails to install during my mydlink camera setup? Lees antwoord
  • How do I configure motion detection on my camera? Lees antwoord
  • How do I configure the audio settings on my DCS-5020L? Lees antwoord
  • How do I enable a new camera in D-ViewCam? Lees antwoord
  • How do I manually upgrade the firmware on my camera? Lees antwoord
  • How do I mount my camera to a wall or ceiling? Lees antwoord
  • How do I reset my camera to factory default settings? Lees antwoord
  • How do I set an administrator (admin) password on my DCS-5020L? Lees antwoord
  • How do I set up and install my DCS-5020L? Lees antwoord
  • How do I set up motion detection and recording in D-ViewCam? Lees antwoord
  • How do I set up scheduled recording in D-ViewCam? Lees antwoord
  • How many types of motion detection are available on my IP camera? Lees antwoord