How do I manually upgrade the firmware on my camera?
Note: All firmware upgrades should be done over a WIRED connection. If your camera is currently configured for wireless, plug it directly into your router before proceeding.
Step 1: Download the latest firmware file for your device from https://www.mydlink.com/support
Step 2: Open a web browser and enter the IP address of the camera in the address bar (default is 192.168.0.20). Press Enter.
Step 3: The default username is admin and the password field should be left blank. Click OK.
Step 3: Click the Maintenance tab and then click Firmware Upgrade from the menu on the left-hand side.
Step 4: Click on Browse to located the downloaded firmware and then click the Upload button. The firmware upgrade will commence. Once completed, the camera will reboot, and you will need to log in to the configuration interface again.
Ti potrebbero interessare anche questi:
- How do I access my mydlink camera remotely? Leggi la risposta
- How do I change the LAN IP address of my camera? Leggi la risposta
- What can I do when Active X fails to install during my mydlink camera setup? Leggi la risposta
- How do I configure motion detection on my camera? Leggi la risposta
- How do I configure the audio settings on my DCS-5020L? Leggi la risposta
- How do I enable a new camera in D-ViewCam? Leggi la risposta
- How do I mount my camera to a wall or ceiling? Leggi la risposta
- How do I reset my camera to factory default settings? Leggi la risposta
- How do I set an administrator (admin) password on my DCS-5020L? Leggi la risposta
- How do I set up and install my DCS-5020L? Leggi la risposta
- How do I set up motion detection and recording in D-ViewCam? Leggi la risposta
- How do I set up scheduled recording in D-ViewCam? Leggi la risposta
- How many types of motion detection are available on my IP camera? Leggi la risposta