How do I enable a new camera in D-ViewCam?
D-ViewCam is a powerful software package from D-Link which may be purchased separately. It is useful for monitoring a large network of up to 32 cloud cameras
Step 1: Launch the D-ViewCam console. Once the console loads, click on the General Settings icon, then Setting, and then click System Setting.
Step 2: Click on the Camera tab.
Step 3: Click Start Scan to automatically find the IP camera(s) that are on your Local Area Network (LAN).
Step 4: Select one of the IP cameras that are available by checking the box in the left-hand column. You may enter a new name for this camera and then enter the administrator username and password assigned to this camera in the fields provided. Click OK to add the camera.
Step 5: The pop-up window will close and the new camera should appear on the list.
If a camera does not support UPnP, you can manually add a camera as per the below instructions.
Step 1: Click Insert to manually add a network camera that is on your Local Area Network (LAN). The IP Camera Video/Server Setting window will appear.
Step 2: Enter the following network information for your camera:
• Name - Enter a name for your camera.
• IP Address - Enter the IP address of this camera. If you want to use a domain name, then check the DNS box and enter the domain name.
• HTTP Port - 80 is the default port.
• User Name - Enter the administrator user name for this camera.
• Password - Enter the administrator password for this camera.
• Protocol - Select TCP, UDP or HTTP.
Enter the following device information for your camera, or click Auto Detect to detect the vendor and model information.
• Vendor - Select the brand name from the dropdown menu.
• Camera Model - Select the camera model from the drop-down menu.
• Video Channel - Select the video channel you want to assign the camera
Step 3: Click OK to add your camera.
These may also help:
- How do I access my mydlink camera remotely? Read Answer
- How do I change the LAN IP address of my camera? Read Answer
- What can I do when Active X fails to install during my mydlink camera setup? Read Answer
- How do I configure motion detection on my camera? Read Answer
- How do I configure the audio settings on my DCS-5020L? Read Answer
- How do I manually upgrade the firmware on my camera? Read Answer
- How do I mount my camera to a wall or ceiling? Read Answer
- How do I reset my camera to factory default settings? Read Answer
- How do I set an administrator (admin) password on my DCS-5020L? Read Answer
- How do I set up and install my DCS-5020L? Read Answer
- How do I set up motion detection and recording in D-ViewCam? Read Answer
- How do I set up scheduled recording in D-ViewCam? Read Answer