How do I configure the audio settings on my DCS‑5020L?

Step 1: Open a web browser and enter the IP address of the camera in the address bar (default is 192.168.0.20). Press Enter.


Step 2: The default username is admin and the password is blank (nothing). Click OK.

 


Step 3: Click the Setup tab and then click Audio to the left.


Step 4: Click Enable in the Audio Settings section.



Step 5: Change the Volume Settings and click Save Settings to retain the changes.


Rank: 1.5

These may also help:

  • How do I access my mydlink camera remotely? Read Answer
  • How do I change the LAN IP address of my camera? Read Answer
  • What can I do when Active X fails to install during my mydlink camera setup? Read Answer
  • How do I configure motion detection on my camera? Read Answer
  • How do I enable a new camera in D-ViewCam? Read Answer
  • How do I manually upgrade the firmware on my camera? Read Answer
  • How do I mount my camera to a wall or ceiling? Read Answer
  • How do I reset my camera to factory default settings? Read Answer
  • How do I set an administrator (admin) password on my DCS-5020L? Read Answer
  • How do I set up and install my DCS-5020L? Read Answer
  • How do I set up motion detection and recording in D-ViewCam? Read Answer
  • How do I set up scheduled recording in D-ViewCam? Read Answer