Step 1: Place the baseplate at the desired location, assuring that it is at least 20cm from the ceiling. Make sure the screw is facing up and the holes are level. Use a pencil to mark the holes.
Step 2: Using a 6 mm drill bit, drill two 25 mm deep holes over the pencil marks. For a plaster, dr y wall, or concrete wall, insert the plastic anchors to support the screws first.
Step 3: Place the baseplate over the holes. Use the supplied screws to attach the baseplate to the wall.
Step 4: Align the large top screw with the largest hole on the snap mount. Slide the mount down to lock into place.
Step 5: Attach the back of the camera to the mount. Adjust the angle as desired.