Step 1. Run HyperTerminal from Start >Programs > Accessories > Communications >HyperTerminal.
Step 2. On the Connection Description window,enter a name for this connection. Click OK.
Step 3. On the Connect To window, select the COMport that the serial cable is connected to using the drop-down boxnext to Connect Using. Click OK.
Step 4. On the COMX Properties (X represents theCOM port number) window, select the following settings using thedrop-down boxes:
- Bits per second - 115200
- Data bits - 8
- Parity - None
- Stop bits - 1
- Flow control - Hardware
You will now see a blank screen which shows Connected at the bottomleft hand corner of the screen.
Step 5. Log into the switch and then reboot theswitch.
Step 6. Press "#" (Shift 3) before the POST runsto 100%.
Step 7. After a short delay, the switch willattempt to establish a connection to the Z-Modem, as shownbelow.
Step 8. Click Transfer -> SendFile, which will open the "Send File" window:
Step 9. Choose the PROM file to be upgraded byutilizing the Browse button and pressing "Send."After the file transfer has completed, the device will rebootautomatically.
IMPORTANT: During the reboot process, DO NOT power off theswitch. Doing so will cause a boot failure and the device cannot berebooted. The RMA (Return Material Authorization) process will beneeded for recovery.
Step 10. After rebooting, the PROM version will bechanged.