How do I configure the audio settings on my DCS-5020L?
Step 1: Open a web browser and enter the IP address of the camera in the address bar (default is 192.168.0.20). Press Enter.
Step 2: The default username is admin and the password is blank (nothing). Click OK.
Step 3: Click the Setup tab and then click Audio to the left.
Step 4: Click Enable in the Audio Settings section.
Step 5: Change the Volume Settings and click Save Settings to retain the changes.
10 Други потребители намират това за полезно.
Беше ли това полезно за Вас?10 Други потребители намират това за полезно.
Благодарим Ви за обратната връзка.
Съжаляваме, че не успяхме да помогнем! Натиснете тук за повече Въпроси и отговори или за да отидете в секция Поддръжка.
Това също може да Ви помогне:
- How do I access my mydlink camera remotely? Прочети отговорите
- How do I change the LAN IP address of my camera? Прочети отговорите
- What can I do when Active X fails to install during my mydlink camera setup? Прочети отговорите
- How do I configure motion detection on my camera? Прочети отговорите
- How do I enable a new camera in D-ViewCam? Прочети отговорите
- How do I manually upgrade the firmware on my camera? Прочети отговорите
- How do I mount my camera to a wall or ceiling? Прочети отговорите
- How do I reset my camera to factory default settings? Прочети отговорите
- How do I set an administrator (admin) password on my DCS-5020L? Прочети отговорите
- How do I set up and install my DCS-5020L? Прочети отговорите
- How do I set up motion detection and recording in D-ViewCam? Прочети отговорите
- How do I set up scheduled recording in D-ViewCam? Прочети отговорите