What if I forget the Admin password for my camera?
(How do I reset my camera to factory default settings?)
Note: After a factory reset you will need to re-register the camera with mydlink. Do not unplug the camera from the power during this procedure.
Step 1: Remove the protective cover from the rear of the unit.
Step 2: With the unit on, use a paperclip to press the button located inside the small hole on the underside of the cavity exposed by removing the protective cover.
Step 3: Press and hold the button inside the hole for 10 seconds and release.
Step 4: The unit will then reboot. Once the LED light on the front of the unit turns green, the unit has been reset and all settings have been restored to their defaults.
33 Други потребители намират това за полезно.
Беше ли това полезно за Вас?33 Други потребители намират това за полезно.
Благодарим Ви за обратната връзка.
Съжаляваме, че не успяхме да помогнем! Натиснете тук за повече Въпроси и отговори или за да отидете в секция Поддръжка.
Това също може да Ви помогне:
- How do I access my mydlink camera remotely? Прочети отговорите
- How do I change the LAN IP address of my camera? Прочети отговорите
- How do I configure motion detection on my camera? Прочети отговорите
- How do I configure the audio settings (microphone) on my DCS-2330L? Прочети отговорите
- How do I find the IP address of my DCS-2330L and access the web-based user interface? Прочети отговорите
- How do I manually upgrade the firmware on my camera? Прочети отговорите
- How do I mount my camera to the wall or ceiling? Прочети отговорите
- How do I set an administrator (admin) password on my DCS-2330L? Прочети отговорите
- How do I set up and install my DCS-2330L? Прочети отговорите
- Which types of motion detection are available on my IP camera? Прочети отговорите