Camera Mounting Instructions Snap Mount

Step 1: Place the baseplate at the desired location, assuring that it is at least 20cm from the ceiling. Make sure the screw is facing up and the holes are level. Use a pencil to mark the holes.

DCS-2802KT_Camera_Mounting

Step 2: Using a 6 mm drill bit, drill two 25 mm deep holes over  the  pencil  marks.  For  a plaster,  dr y wall,  or concrete wall, insert the plastic anchors to support the screws first.

DCS-2802KT_Camera_Mounting

Step 3: Place the baseplate over the holes. Use the supplied screws to attach the baseplate to the wall.

DCS-2802KT_Camera_Mounting

Step 4: Align the large top screw with the largest hole on the snap mount. Slide the mount down to lock into place.

DCS-2802KT_Camera_Mounting

Step 5: Attach the back of the camera to the mount. Adjust the angle as desired.

DCS-2802KT_Camera_Mounting

Rank: 3